Mô tả sản phẩm: Engenius EAP1750H
Technical Specifications
Hardware
RF: 2.4 and 5 GHz Frequency Bands
Standards: IEEE 802.11a/n/ac on 5 GHz; IEEE 802.11b/g/n on 2.4 GHz
Radio I: 11b/g/n: 2.412~2.484 GHz
Radio II: 11a/n/ac: 5.18-5.24 and 5.26-5.32 and 5.5-5.7 and 5.745-5.825 GHz
Data Rate: Up to 1300 Mbps in 5 GHz; Up to 450 Mbps in 2.4 GHz
Memory: 128MB
Flash Memory: 16MB
Peak Power: Up to 22W
Antenna Array
Integrated 3D Sectorized Antenna Array
4 dBi on 2.4 GHz
5 dBi on 5 GHz
Physical Interface
1 x RJ-45 Gigabit Ethernet Port (10/100/1000 Mbps)
1 x Reset Button
1 x Power Connector
LED Indicators
Power
WPS
2.4 GHz
5 GHz
LAN
Power Requirements
Power Supply: 90 to 240 VDC ± 10%, 50/60 Hz
(depends on different countries)
Active Ethernet: (Power-over-Ethernet, IEEE 802.3at)
Power Adapter: 12V/2A
Modulations
OFDM: BPSK, QPSK, 26-OAM, 64-QAM, DBPSK, DQPSK, CCK
Operating Channels
2.4 GHz: US/Canada 1-11
5 GHz: Country dependent for the following ranges:
36, 40, 44, 48, 52, 56, 60, 64, 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140, 149, 153, 157, 161, 165
Software
Topology
Infrastructure/Ad-Hoc
Operation Modes
Access Point, WDS Bridge, WDS Access Point
Multiple BSSID
Supports up to 8 BSSIDs per radio
LAN
IP (check validity and DHCP server IP range) MAC
SSID-to-VLAN Tagging
Supports 802.1q SSID-to-VLAN tagging
Spanning Tree
Supports 802.1d Spanning Tree Protocol
Wireless
Wireless Mode: 11a/11b/11g/11n/11ac
Channel selection (settings vary by country)
Channel bandwidth (Auto, 20 MHz, 40 MHz)
Transmission rate:
2.4 GHz: 11n only, 11b/b/n mix, 11b only, 11b/g, 11g only
5 GHz: 11n only, 11a/n mix, 11a only, 11ac only
QoS
WMM (Wireless Multimedia)
VPN
Pass-through (PPTP, L2TP, IPSec)
WPS
Software only
Management
Tx Power Control:
Adjust transmit power by dBm
Configuration:
Web-based configuration (http)/Telnet
Telnet Server:
CLI
Firmware Upgrade:
Via web browser, settings are reserved after upgrade
Administrator Setting:
Administrator Username and Password Change
Reset Setting:
Reboot (press 1 second).
Reset to factory default (press 10 seconds)
System Monitoring:
Status Statistic and Event Log
SNMP:
V1, V2c, V3
MIB:
MIB I, MIB II (RFC1213) and private MIB
Traffic Shaping:
Incoming and outgoing wireless traffic shaping
Auto-channel Selection:
Automatically selecting least congested channel
Bandwidth Measurement:
IP range and bandwidth management
Auto Reboot:
Reboot Access Point by minute, hour, day, or week
Backup and Restore:
Save and restore settings through Web interface
CLI:
Supports Command Line Interface
Diagnosis:
IP pinging statistics
Log:
SysLog and Local Log support
LED Control:
On/Off
AP Detection:
Scanning for available EnGenius APs
Wireless / Network
PPTP: Point-to-Point Tunneling Protocol (PPTP) is a method for implementing virtual private networks
Wireless Security
WPA/WPA2 Personal (WPA-PSK using TKIP or AES)
WPA/WPA2 Enterprise (WPA-EAP using TKIP)
802.1X RADIUS Authenticator: MD5/TLS/TTLS, PEAP
SSID broadcast enable/disable
MAC Address Filtering, Up to 50 fields
Wireless STA (Client) connected list (Idle/Connection Time, Pkt statistics)
QoS (Quality of Service)
WMM (Wireless Multimedia)
Environmental & Physical
Temperature Range
Operating: 32º to 104ºF (0º to 40ºC)
Storage: -4ºC to 140ºF (-20º to 60ºC)
Humidity (non-condensing)
Operating: 90% or less
Storage: 90% or less
Certifications
FCC, IC
Maximum data rates are based on IEEE 802.11 standards. Actual throughput and range may vary depending on many factors including environmental conditions, distance between devices, radio interference in the operating environment, and mix of devices in the network. Features and specifications subject to change without notice. Trademarks and registered trademarks are the property of their respective owners. For United States of America: Copyright ©2014 EnGenius Technologies, Inc. All rights reserved. Compliant with FCC - This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his/her own expense.
Dimensions & Weights
Weight: 0.62 lbs.
Diameter: 6.36”
Height: 1.64”
