Model | Through-Beam | Diffusion Reflection | Retro Reflection |
| | | | |
PR-T10NC | PR-T10NP | PR-R300NC | PR-R300NP | PR-M1NC, PR-M1NP |
Sensing Distance | 10 m | 300 mm | 1 m(0.1-1 m) |
Sensing Object | opaque object above Ø 10 mm |
non-glossy and white | paper above 200 x 200 mm |
|
transparent, translucent, | opaque object above Ø 25 mm |
|
Hysteresis | - | Below 20 % of sensing distance | - |
Response Time | Below 1 ms |
Rated Voltage | 12 - 24 V DC ( ± 10 %) |
Current Consumption | Below 35 mA | Transmitter:15 mA / Receiver:20 mA |
Light Source | Infrared LED (Modulation Method) |
Adjusting Sensitivity | Built-in Adjusting Sensitivity Volume (but, Through-Beam has only in the receiver) |
Control Output |
NPN Voltage Output, Loaded Voltage: below 30 V DC, | Loaded Current:below Max. 200 mA, Residual Voltage:below 1 V |
|
Operation Mode | By control line, Light ON/ Dark ON / Selecting Mode Switching (but, Through-Beam has only in the receiver) |
Operation Indicator |
Operation Indicator (Red LED), Stability Indicator (Green LED) | (but, the transmitter (Red LED) of Through-Beam is Power Indicator) |
|
Protection Circuit |
Built-in Protection Circuit from reversed power supply | connection, Output Short-Circuit Overcurrent circuit protection |
|
Operating Ambient temp. | Operating: -10 ~ 60 °C, Storage: -25 ~ 70 °C (without freezing) |
Operating Ambient Humidity | 35 - 85 % R.H. |
Operating Ambient Illumination | Sunlight: below 11000 Lux, Incandescent lamp: below 3000 Lux |
Case Protection | IP67 (IEC Standard) |
Vibration Resistance | 10 ~ 50 Hz (cycle for 1 minute), double amplitude: 1.5 mm, in each direction X•Y•Z for 2 hours |
Shock Resistance | 500 m/s² (approx. 50 G), X•Y•Z for 3 times |
Dielectric Strength | 500 V AC (at 50/60 Hz for 1 minute) |
Insulation Resistance | Above 20 MΩ (500 V DC) |
Connection Method | Cable Length: 2 m (Ø 4 mm, 4P) but, the length of the transmitter of Through-Beam: 2 m (Ø 4 mm, 3P) |
Acce ssories | Individual | - | Reflector (Mirror 50 x 50) | - |
Common |
Screw driver for adjusting sensitivity, nuts, washers | (But, the nuts of Plastic Type are injection molding products. (except washers)) |
|
Bình luận