Liteguide Controller Ae1000 - Ae1000 Nireco - Nireco Việt Nam Bộ Điều Chỉnh Biên

Power Supply Voltage

AC100 to 240V 50/60Hz ±10%

Power Consumption

300 VA (inrush current 100 A 10 ms typical (200 V))

Power Fuse

250V AC, 3.15 A (time-lag type)

Ambient Operating Temperature

0 to 50°C

Ambient Operating Humidity

35 to 85% RH or lower (no condensation)

Vibration Resistance

3.5 mm, 1 G, 3 to 150 Hz, three-directions (1hour)

Power supply Noise

2.5 kVp-p, normal mode, common mode 50 ns, 1μs width

Usage atmosphere:

Area with no water, flammable or corrosive gases, and little dust.

Mass

Approximately 5 kg

IP Class

IP30

Input

2 Sensor systems

Voltage input Maximum ±5V（No input resistance）
Current input 0-20mA (input resistance converted to 240/2kΩ)

2 analog shift systems

Voltage input Maximum ±10V

Centering

Proximity switch input （0-8V, 1.2kΩ input resistance）（Applies to: KL1632. 0-90P）

Position Transmitter

Voltage input Maximum ±10V

Photo coupler input 
（12V DC, 15mA）

Remote controller :
Operation mode switching（auto / manual / centering）
Operation keys （left / right / auto balance / reverse）
System selection（EPC1 / EPC2）
Locks 3 points
Actuator end limit :
2 points

Output

Electrical actuator

K12 ±24V DC, 1A(maximum) or K62 ±36V DC, 2A(maximum)

Lamp power source

4 to 12V DC, variable （maximum 1A）

Fine tuner, Position transmitter, LH8B

±5V power source （maximum 0.1A）

Sensors

±15V power source （+15V, 1A; -15V, 0.2A）
（Note: The current capacity on the + side combined with the lamp power source in(2) is less than 1A.）

Centering proximity switch power source

8V DC （maximum 30mA）

2 indicator systems

Voltage output Maximum ±10V （load resistance 2kΩ or greater）
Deviation output
Position transmitter output

Photo coupler output
（24V DC, 40mA）

Remote controller :
Operation mode state（auto / manual / centering）
System state （EPC1 / EPC2）
Alarms Excessive deviation
End limit
Actuator lock
Actuator excessive load