Cev 4 Mô Đun Điều Khiển, Cev 4 Paolo Colombo Viet Nam

Hotline: 0933.911.903

Mail: thietbicongnghiepltt@gmail.com

Liên hệ với chúng tôi để có thêm thông tin và giá tốt nhất!

This device is used for controlling pneumatic brake/clutch engagement systems and is suitable for controlling a double safety solenoid valve.
The circuit features to override contact relays.

Two-hand manual control, safety category pr EN 574 Type lll C.

Mobile protection guard control

Diagnostics and operation phase displayed on front on module.

Timed adjustment cycle control

Electromechanical relay electrical and mechanical life duration check

Strike anti-repeat control, with possibility of set-up with three key switches for the following operating cycles:
1) by hand for maintenance operations – safety devices off – safety devices on
2) by means of repeat pedal – pedal and buttons (two-hand control)
3) adjustment cycle – single strike – continuous.
Single/continuous operating cycle feature overstroke control.

Operation and connections

Controls fitted on front of device.
The pulse-single-continuous switch 20 is used to select the working cycle of the machine.
Pulse operation 17 is used for tuning operations. The machine will only work for a certain pre-set time in this position.

Single strike operation 18 is used to make the machine run a single cycle. Strike repetition will only be possible after fully releasing the buttons and repeating the control. Continuous operation 19 is used to run the machine. After being started, the machine can be stopped by means of the R.P.M.S. or emergency stop buttons.
The continuous pedal-pedal-buttons switch 15 is used to identify the type of device used to start the machine.
Button position 14 enables the push-button panels (the pedal must be off). Position 13 enables the pedal control. Position continuous pedal-continuous 12 enabled continuous machine operation controlled by means of the pedal while the pedal is pressed.
Motor cut-off/die protection TOOL OFF-TOOL ON switch 24 is used for maintenance operations. Position motor cut-off 21 allows the running the brake/clutch unit with the main motor off. Die protection positions TOOL OFF 22 and die protection position TOOL ON 23 respectively deactivate and activate the die efficiency limit switches. Switch 20 will immediately stop the machine while it is running. The machine will immediately stop if controls are released during tool descent. Releasing the controls after BDC will not effect normal operation (continuous-single). Any alarm or emergency will stop the machine. Start controls must be fully released for the machine to repeat a work cycle. Operation of the two control buttons which can be connected to the machine must be synchronised within 0.5 sec. More push-button panels can be connected upon request.

Technical features

√ Power supply 24V +/- 15% a.c.
√ Power consumption about 40VA.
√ The protection fuses 25-26 are included in the appliance.
√ Solenoid valve power supply 220Vmax. Recommended maximum operating frequency 180 cycles / min.
√ The totalizer of the pieces produced is also provided.
√ Appliance front size mm. 96 x 192. Fixing with two tie rods.